Technology News
Toshiba’s first ARM Cortex-M0 microcontroller is optimized for smart meters
May 29, 2012 | Paul Buckley | 222904660
Toshiba Electronics Europe is launching a 32-bit RISC microcontroller built around the ARM Cortex-M0 processor core. The new TMPM061 is also Toshiba's first Cortex-M0 device specifically designed for smart metering applications.
The new microcontroller allows designers to replace the conventional two-chip analog front end (AFE) and processor approach to smart meter design with a single IC.
ARM’s smallest processor, the ARM Cortex-M0 delivers small silicon area, low power and minimal code footprint, making it ideal for smart meter designs. Toshiba has used this core for its new microcontroller’s main CPU, while deploying an on-board DSP power calculation engine to simplify smart meter power measurement. The power calculation engine can calculate active energy, reactive energy and power factor as well as monitoring voltage and frequency fluctuation. Flexibility is enhanced as the basic energy use calculation function can be updated and modified by the developer as necessary.
As well as the power calculation engine the TMPM061 offers a variety of on-board functions that will minimize the component count of smart meter designs. These include a three-channel, high-precision 24-bit Delta-Sigma (∆∑) analogue-to-digital converter (ADC), a 10-bit ADC and a temperature-compensated real-time clock (RTC). The ∆∑ ADC supports simultaneous sampling at up to 6 kHz and has a SINAD (signal-to-noise and distortion ratio) that is suitable for a residential meter.
Toshiba is providing the TMPM061 with up to 128 Kbytes of on-chip Flash ROM and 8Kbytes of available on-chip RAM. Additional on-board peripherals include a 9-channel, 16-bit timer, a controller for directly driving an LCD display, a temperature sensor, a voltage detection circuit and a watchdog timer. Integrated connectivity comprises a 5-channel general-purpose serial interface (selectable between UART mode and synchronous mode) and a serial bus interface. The latter offers a choice of I 2 C bus mode or synchronous mode operation.
The TMPM061FWFG is supplied in a 14 mm x 14 mm 100-pin LQFP package and will operate with input voltages from 1.8 V to 3.6 V. Maximum operating frequency is 16 MHz. Four standby modes (IDLE, SLOW, SLEEP, STOP) ensure minimum power consumption for a range of conditions.
Availability
Samples of the new microcontroller will be available from August 2012, with mass production scheduled for December 2012.
Visit Toshiba Electronics Europe at www.toshiba-components.com
ARM’s smallest processor, the ARM Cortex-M0 delivers small silicon area, low power and minimal code footprint, making it ideal for smart meter designs. Toshiba has used this core for its new microcontroller’s main CPU, while deploying an on-board DSP power calculation engine to simplify smart meter power measurement. The power calculation engine can calculate active energy, reactive energy and power factor as well as monitoring voltage and frequency fluctuation. Flexibility is enhanced as the basic energy use calculation function can be updated and modified by the developer as necessary.
As well as the power calculation engine the TMPM061 offers a variety of on-board functions that will minimize the component count of smart meter designs. These include a three-channel, high-precision 24-bit Delta-Sigma (∆∑) analogue-to-digital converter (ADC), a 10-bit ADC and a temperature-compensated real-time clock (RTC). The ∆∑ ADC supports simultaneous sampling at up to 6 kHz and has a SINAD (signal-to-noise and distortion ratio) that is suitable for a residential meter.
Toshiba is providing the TMPM061 with up to 128 Kbytes of on-chip Flash ROM and 8Kbytes of available on-chip RAM. Additional on-board peripherals include a 9-channel, 16-bit timer, a controller for directly driving an LCD display, a temperature sensor, a voltage detection circuit and a watchdog timer. Integrated connectivity comprises a 5-channel general-purpose serial interface (selectable between UART mode and synchronous mode) and a serial bus interface. The latter offers a choice of I 2 C bus mode or synchronous mode operation.
The TMPM061FWFG is supplied in a 14 mm x 14 mm 100-pin LQFP package and will operate with input voltages from 1.8 V to 3.6 V. Maximum operating frequency is 16 MHz. Four standby modes (IDLE, SLOW, SLEEP, STOP) ensure minimum power consumption for a range of conditions.
Availability
Samples of the new microcontroller will be available from August 2012, with mass production scheduled for December 2012.
Visit Toshiba Electronics Europe at www.toshiba-components.com
Please login to post your comment - click here
Related News
- Imec and Renesas collaborate on ultra-low power short range radios
- Miniature 30-V MOSFETs claim industry-leading RDS(ON) performance
- EU antidumping duties could block Chinese modules out of the European Market
- 2-kVA frequency converter delivers clean sine-wave output from generator voltage
- 600-V Super Junction MOSFETs with reduced recovery times improve efficiency performance
- Ultra-low on-resistance dual load switch offers system power benefits
- Advanced microcontroller combines floating point and low leakage technology to achieve longest battery lifetime in portable applications
- Wandboard community embedded development board now available from Future
- Mouser signs global distribution deal with ADI
- Digi-Key Corporation selects Wurth Electronics Midcom to be exclusive distributor for planar transformer series
MOST POPULAR NEWS
- KTH The Royal Institute of Technology develops world's first water-activated charging device for mobile phones
- Volvo evaluates flywheel hybrid drive - fuel savings of up to 25%
- PV storage market is set to grow to USD19bn by 2017
- Energy harvesting wireless switch transmits on-off data over a 300m range at 868MHz
- Accutronics offers new custom battery service
- Nordic Semiconductor releases world's smallest Bluetooth low energy and ANT+ ICs
- Power-One enters into patent license agreement with Microchip
- Quad-MOSFET solution boosts efficiency and eliminates heat sinking in active bridge applications
- Advanced microcontroller combines floating point and low leakage technology to achieve longest battery lifetime in portable applications
- Market for GaN and SiC power semiconductors set to rise by factor of 18 in next decade
Interview
Technical papers
- High Voltage Surge Stoppers Ensure Reliable Operation During Power Surges
- Motor-Drive Design made Simple
- Adaptive Cell Converter Topology Enables Constant Efficiency in PFC Applications
- Micropower Isolated Flyback Converter with Input Voltage Range from 6V to 100V
- Derating of Schottky Diodes
- Heatsink Optimization
- High Performance ZVS Buck Regulator Removes Barriers To Increased Power Throughput
- Waste heat replaces batteries
- Stepper Motor Control IC
- 50Ω Gain Block IF Amplifier
Poll
Linear Technology
Power
Photovoltaic
Maxim Integrated Products
NXP Semiconductors
Fairchild Semiconductor
SoC
Microcontroller
Battery
Intersil
MOSFET
International Rectifier
UPS
Power Supplies
Batteries
Diodes
Solar
Vishay Intertechnology
IMS Research
Texas Instruments
MOSFETs
Power Supply
Power Management
Analog Devices
Microcontrollers
Smart Grid
Analog
STMicroelectronics
National Semiconductor
Energy Harvesting
All material on this site Copyright © 2009 - 2010 European Business Press SA. All rights reserved.
This site contains articles under license from EETimes Group , a division of United Business Media LLC.
This site contains articles under license from EETimes Group , a division of United Business Media LLC.


